This post provides an operation guide for the Xhorse XKGMJ1EN Garage Remote Key (4 Buttons), including:
- Delete code status
- Clone
- Switch frequency
- Set frequency
- Recover data
Xhorse XKGMJ1EN Wire Remote Key Garage Door 4 Buttons Hardware:
Includes LED, UP, Down, Lock, and Pause buttons
Each XKGMJ1EN Wire Key can get 25 Bonus Points when first using.
1.How to delete code status?
Press the ‘Up’ and ‘Down’ buttons at the same time until the LED goes out and then release it
Step 2
Press and hold the ‘Pause’ button, and keep the light on until the LED goes out
2.How to clone?
Step 1: Operation
1) Press and hold any one button of garage remote, this remote will enter cloning mode,
LED will flash once then off (Keep pressing the button)
2) Press and hold original remote corresponding button, and put the original remote next to garage remote.
Once the LED light is on that means the current button cloning is successful.
3) Follow the above steps to copy all function buttons in turn.
Step 2: Verification
Press and hold any button, and the LED will be on for a long time which means that the clone is successful.
3.How to set frequency?
Step 1: Enter mode
Press the ‘Lock’ and ‘Pause’ buttons at the same time, then release them until the LED goes out
Step 2: Set frequency
Press the ‘Up’ button, and the LED will flash once every time you press it
(Query the frequency point reference table. For example, press 8 times to correspond to 433.92 frequency point)
Step 3: Check frequency point
After setting up the frequency point, wait for five seconds for the LED to flash for the corresponding times as frequency reference table shown.
Step 4: Exit mode
After the LED stops flashing, immediately press the ‘Lock’ and ‘Pause’ buttons, the LED will light on and release buttons until LED light off.
Frequency edition by device:
When the remote control frequency is not in the frequency point comparison table, the original remote control data can be copied with the above devices. Any frequency can be modified and written to the garage remote.
4.How to regenerate Roll code ID?
Applicable conditions:
If the cloned garage remote has code tracking, it can be solved by matching and the rolling code ID is regenerated.
Step 1
Press and hold the ‘Up’ and ‘Lock’ buttons at the same time until the LED goes out and then release
Step 2
Press and hold the ‘Pause’ button and keep the light on until the LED goes out
5.How to recover data?
Step 1: Status detection
Press and hold any button
If the LED flashes quickly and goes out, the code has been deleted
Step 2: Data recovery
Press and hold the ‘Down’ and ‘Pause’ buttons at the same time, and the data recovery will be completed when the LED is on
Step 3: Test result
Press and hold any button, and the LED will be on for a long time, then the data recovery is successful.
Xhorse XKGMJ1EN Wire Remote Key Garage Door 4 Buttons English 10pcs/lot:
https://www.xhorsetool.com/wholesale/xhorse-xkgmj1en-garage-remote-key.html
