MQB RH850/V850 R7F701407 Key Programmed by Xhorse Multi-Prog and VVDI2

Uncategorized

Written by:

Here is a new demonstration using Xhorse Multi-Prog Programmer and VVDI2 to read MQB-RH850 R7F701407 dashboard IMMO data, make dealer key, and add key. Xhorse XDMPR8GL MQB RH850/V850 Adapter is required to perform this function. It makes the job easier and safer. No need to cut the wire or lift the pin!

STEP 1

Connect Xhorse tools, 1407 dashboard and PC

Run Multi- Prog software

Select Device>> 1407>> MQB48-LOCK (R7F701407)-> READ (VW-> MQB) >> Detail

Check the connection diagram

Use a tweezer and heat gun to remove the 8 capacitors according to the diagram

Scrape the PCB mask before soldering the GND wire to the soldering point

Solder the wires of Xhorse MQB RH850/V850 Cable to the corresponding position on 1407 dashboard PCB

Secure the wires with acetate tape

Connect MQB RH850/V850 Adapter to Multi-Prog Programmer

Connect Multi-Prog and VVDI2 Programmer to the PC by USB cables separately

Don’t forget to connect the 12V power supply to Multi Prog as well

STEP 2

Read chip data by Xhorse Multi Prog

After connection, select “Crack Reading” to decode the chip and read the chip data.

You can check the read process in the bottom left corner. Wait patiently for a few minutes.

After the chip is reading successfully, click on “Save file” to save it.

STEP 3

Read IMMO data, make dealer key and add key by Xhorse VVDI2

Run VVDI2 software and select “VW”

Select Key Learn>> MQB platform instrument immobilizer>> Instrument with locked NEC35xx (MQB48, VDO/JCI)

Select “Decode immodata”

Click on “Yes” to load the encrypt data read by Xhorse Multi-Prog

Open the file

Decoding is successful, press “OK” to save the IMMO data file

Finally, use the IMMO data to make dealer key and add key.

 Read also:

Multi-Prog Programmer and VVDI2 program MQB RH850/V850 R7F701402 key

Xhorse Multi-Prog and VVDI2 Program MQB RH850/V850 1402 Dashboard Key

 

Copy Protected by Chetan's WP-Copyprotect.