Is there a method to perform single ECU module diagnostic and programming easily by VVDI2 key programmer?
The answer is Yes. GODIAG GT100 ECU Breakout Box will make the job easier.
What is Godiag GT100?
GODIAG GT100 is a brand new ECU connector and protocol communication testing tool. It will greatly help a user to connect the ECU module separately for diagnosis, programming and coding. Also it will tell whether the diagnostic & programming tool can normally send out communication signal.
How to use Xhorse VVDI2 with GODIAG GT100?
i.e: test VW engine
Preparation:
Car ECU module: VW MED 17.5
VVDI 2 key programmer
GODIAG GT100 Auto Tools OBDII Break Out Box ECU Connector
PC
Step-by-step guide:
1.Follow the connection diagram to connect all the devices firstly.
Step 1: Connect GODIAG GT100 with ECU module via colored jumper cable depend on the following wiring diagram
Step 2: Connect GT100 and VVDI2 via OBD 2-in-1 extension cable (comes with GODIAG GT100 package) and OBD2 cable (comes with VVDI2 programmer package)
Step 3: Connect VVDI2 key programmer to computer via USB cable
Step 4: Supply power to GODIAG GT100 by an AC power adapter
Turn on the power switch of Godiag GT100
2.Now enter the operation process.
Step 1: Open VVDI2 software
Select “VW”-> “Engine”
Then press “Connect”
Identify the ECU successfully
Step 2: Select “Read DTCs”
Read out the corresponding fault codes.
If you are interested in GODIAG GT100 OBD2 ECU Connector, you can contact the customer service to learn more info.