Here will share the guide to cut a key by code with Xhorse Dolphin XP005 on a 2014 Nissan Versa. Key duplication has never been this easy or so mobile, the Dolphin XP-005 portable key cutting machine is truly amazing. This is better than just duplicating a key as it does not pass on any ware or errors to the new key.
Main operation guide:
Turn on this Dolphin key cutting machine
First locate your desired blank key
Insert the original key into M1 clamp
Open Xhorse APP and select “Vehicle Database”
Select Vehicle make and model
Choose the matching key blank code (In this case NSN14)
Confirm clamp type for the blank used
The duplicator will check to make sure alignment and position are good before cutting. If you get an error, adjust and retry
After scanning successfully, confirm the cut matches original key
If the scanning is correct, insert the blank and align as previously instructed
Then press “Cut” to begin duplication
Brush off newly cut key, inspect and compare to the original one
Finally, use the original key and new key has been cut just now to start the car, both work well!
Awesome! Key cutting is simple and easy with the Xhorse APP and Dolphin XP005 key cutter.