Here have collected the common problems of Xhorse Dolphin XP005 automatic key cutting machine that customers encounter, and offer the related solutions for reference.
- Error 01:
- Error code 6& Error 56
- Error Code 7:03:00:00:00
- Be locked and stop working
1. Error 01
Click ‘Fix internal error’ in the repair menu of Xhorse Update Kit software
Update firmware again
2. Error code 6& Error 56
Check the steps as the prompts. (height level adjustment, clamp calibration etc.)
Do the electrical conductivity measurement.
If the cutter and the probe don’t conduct, disassemble the machine and test abnormal conductivity of the cutter/probe.
How to do electrical conductivity measurement?
Go to Xhorse app.
Device information>>Electrical Conductivity Measurement
1)Probe and clamp
2)Cutter and clamp
Use a blank key or a conductor to short-circuit the clamp and the probe/cutter as the prompt.
Note: It also applies to the situation that Dolphin XP005 makes strange noises at the beginning and end of work, the key that is cut also not flat.
3. Error Code 7:03:00:00:00
Open Xhorse update kit software
Click Repair>> fix internal errors 1&2 on the top right of the menu
After fix successfully, click ‘Upgrade’ to update the firmware again.
4. Be locked and stop working
Update Xhorse Upgrade kit to the newest version
Install DOLPHIN Driver from the Xhorse Upgrade Kit folder (if you have installed before, ignore this step)
Connect Dolphin XP005 key cutting machine to the computer via USB cable
Then select device “DOLPHIN 1”, upgrade version 1.5.0 and click “Find Device”, then click “Upgrade”
Note: If the connection between device and computer is normal and device driver has been recognized successfully, just click “Upgrade” directly.
Reference: Xhorse Dolphin XP005 Stop Working Solution