GODIAG G-V ECU Cable can be used to connect Xhorse MULTI PROG with GT107 or GT107+, GPT BENCH BOOT to read and write data on VAG gearbox ECU and engine ECU, clone ECU. It has been confirmed to work well on MED17.8.8 TC1728 reading.

Operation guide:

1.Prepare all required tools as shown is the figure below

2.Follow the corresponding wiring diagram to connect GODIAG ECU GPT BOOT AD Connector and MED17.8.8 ECU

3.Connect GODIAG GPT Boot Adapter and Multi Prog via the GODIAG G-V ECU Cable

4.Connect Multi Prog to computer via USB cable, and supply power to the device as well

5.Run Multi Prog software, search me17.8.8 to find the corresponding ECU model (ALL_BOSCH_ME17.8.8_TC1728_HW2 (BAIC MOTOR)

6.Read INT EEPROM data and save it

Need to power on GODIAG ECU GPT Boot AD

7.Read INT FLASH data and save it

Both work well!