How to Cut Key after Changing Cutter by Xhorse Dolphin XP005?

Question:
If a cutter breaks on a Dolphin XP005, is there a way to continue cutting the key after changing the cutter? It seems it would be problematic because the probe would no longer see it as an uncut key.

Answer 1:
Only way is to put a blank in and after it indexes the key pause it and switch it out.

Answer 2:
There is an option to only make certain cuts on the key. Used for progression.

Customer’s feedback:
Yep. I had my dolphin run out of battery in the middle of a cut, you have to put a blank inlet measure it or prove it then remove the blank and put your semi cut key back in.

Credits to @ David Noble @ Joey Russell @John Holding

www.xhorsetool.com

Copy Protected by Chetan's WP-Copyprotect.