VAG 48 chip keys copy using VVDI2

Xhorse VVDI2 VAG key programmer can copy 48 transponder, without binding a Condor Mini key cutting machine.



Vvdi vag 1.2.6 download on Mega:!2lRTTL4C!FY847AYSd3ASGbS3b2Wh5EQr53foU4u96xngbefsItY

Require vvdi2 firmware v2.2.5


Run VVDI2 VAG software

Select Key learn in the menu

Then 4th immobilizer system – copy 48 transponder:

Step 1

Copy 48 procedure require PIN and component security bytes from cars

Select Get component security from engine control unit via obdii


Step 2

Connect the emulator to VVDI2 commander and switch ON ignition with the emulator, switch OFF/ON for 3 times

(attention: it requires OBD when lost all key)


Step 3

Decode the collected data via internet, and save the “calculate 48 data”. You can copy/prepare key with “calculate 48 data”

(attention: every success calculation will cost 100 remote points)


Step 4

Learn the new key with “calculate 48 data”. If the key was made by copy, it can start engine without learn


[Note 1] About new adapter Vvdi2:

some nec24c32 nec24c64 nec35XX all key lost not need remove instrument.(need read cs from ecu).


[Note 2] About copy 48 function on VVDI2:
(1) Authorize copy 48 function require 1000 remote points, require buy an extra emulator
(2) You can exchange it with “Transponder Programmer -> Menu -> Points System”
(3) Every success calculate will cost 100 remote points
(4) Copy 48 fucntion use in 4th immobilizer system(Dashboard), support type: NEC24C32, NEC24C64, NEC24C64 colordisplay, A1, A3/TT/R8, Q3, New tiguan 5ND920873B, 5ND920883B etc
(5) Copy 48 fucntion can work on the car that which support read PIN and CS via OBDII. Ofcourse, known CS and PIN is supported. Support make new key, support add keyless GO keys, especially support lost all key
(6) For Passat B6/CC only support clone 48 transponder(must have working key), don’t support 46 transponder, dont support keyless Go, dont support lost all key

VVDI2 Copy VAG 48 Transponder Function Authorization: