CONDOR XC-MINI PLUS II Tutorial: How to Duplicate Mul-T-Lock Dimple Key?

Condor XC-Mini Plus

Written by:

In the last article, I introduced how to engrave on a key blank by using Xhorse Condor XC Mini Plus II. Today, I’ll show the steps of cutting Mul-T-Lock dimple key household key.

Preparation:

Original key

Blank key

Cylinder

1.0mm probe

Dimple cutter (internal)

Dimple cutter (external)

M5 clamp

CONDOR XC-MINI PLUSⅡ

Step-by-step guide:

Step 1: Height calibration

Stick in the probe and the dimple cutter (internal)

Make sure the clamp is tightened

Hit Settings>> Device Calibration>> height calibration>> Start

Tips: Install M5 clamp then select A position A is upwards and tighten left, don’t insert key blank

Height calibration complete

Step 2: Key learning

Select Household>> All regions>> Mul-T-Lock (8.8mm-R)>> Mul-T-Lock 4-4

Insert the original key

Hit ‘Decode key’ to start the key learning

Household key learning completed

Step 3: Key cutting

Insert the blank key and close the cover

Hit ‘Start cutting’>> OK

After cutting, clean the shavings and remove the key

Tighten the clamp and install the dimple cutter (external)

Repeat height calibration again

Select Dimple (external)>> probe and cutter setting>>  6*100* dimple (external)>> Save

It will prompt ‘Machine parameter modify successfully, perform height level adjustment’.

Click OK>> Start

Calibrate the height again

Insert the key and start to cut the external cuts

Click OK>> Start cutting

Cut one side of the key successfully, then flip the key to cut another side

Key cutting is completed

Finally, insert the key into the cylinder to test

Done!

Alright! That’s the whole process to duplicate Mul-T-Lock dimple key by using Xhorse CONDOR XC-MINI PLUSⅡ key cutting machine.

Copy Protected by Chetan's WP-Copyprotect.