VVDI2 6.1.0 Update Tips & Guides

Xhorse VVDI2 6.1.0 update tips and guides:

1. Fully uninstall then install again,you may need to turn off driver signatures
2. Pulled the sub cable in and out A couple of times changed ports too , it worked
3. Also check the firmware is up to date

4. you need to update the computer software, your firmware on vvdi2 device is 6.1.0 but u most likely need to update software on computer , or if you did that first start the updater and after that plug in thw vvdi2 device

5. Updated driver

6. Check if your driver is installed correctly or not. It should result from the driver installation!

This is for the error message below:
Not found device
Error – Cannot find vvdi2, reconnect VVDI2 and try again!

How to update VVDI2 to version 6.1.0 successfully (no errors)

Here are my experience of Xhorse VVDI2 6.1.0 update


Just updated vvdi2 too version 6.1.
When I open it says v6.0
Transponder programmer can’t find device.


The download link i used:



Have updated the firmware 1.5


Check the file in C: and delete the short cut for old version




Delete all vvdi2 files and re install the software

Cheers, on vvdi2 v6.1.0 now