How to do a spare key to Passat 2010: Done with VVDI2 + VVDIprog

This is the procedure to help do a spare key to a Passat 2010 (optional solutions)

 

Method George Alin used:

Remove CCM(comfort) module .read 95320 eeprom … make dealer key … learn key on car ..Done

if it’s a spare deffo through OBD can get 7th byte from working key.

i like to be 100% covered that’s why i choose that method.

Method Jerry King used:

Read cs and pin from vehicle.

Go to transponder tools , find 7th byte with existing key.

Put in the 6 it pulled and insert the old key to find the 7th.

Write the 7 bytes to new key.

Go back to VW tool and write that key.

Go to diagnostics , comfort module program remote.

The entire job takes 5 minutes or less you do not need to pull anything.

My experience applies to USA market only.

Method Jimmy Sadler used:

You can clone the chip then program the remote

The easiest and quickest method for a spare.

It separate from Chip and remote program separately

the chip is in side of the remote just open it up you will see the chip

Method Craig Bowie used:

Here are my notes they are for the zedfull but I have also done it with the vvdi prog and the vvdi2

With the VVDI prog read out of Circuit with the eight leg reader then open VDI to transponder programming pick the car and load the file add key

Credits to all the contribution in the XHORSE group: https://www.facebook.com/groups/xhorsetools/

vvdi2 programs a new key to vw touareg 2010

Instructions:
1_ turn ignition on with working key .
2_ get pin code and cs code.
3_ make dealer key with know 7th bit.
3_ key learning and i put 2 key.
4_ turn ignition off thin ignition on with working key. And press ok thin turn ignition on with all key thin press ok .

 

Note that in the process of inserting each key and giving it ON
Each key should not be ON more than 5 seconds (better 2 seconds ON), else, the system will close on the first key which exceeds 5 seconds!

You should repeat again learning all keys.

 

Tech support from xhorsetool.com

VVDI2 program 2013 Passat slot key AKL (FAQs)

Confirmed! Xhorse vvdi2 can work for 2013 Passat slot key AKL.

 

By dump! Not through the obd!

 

Q: Do you need a special cable for the dump?

A: Vvdi prog or other eeprom programmer

 

Q: When you select the car on vvdi2 what the tool ask for ?

A: I havnt been out to the car yet, just asking for advice…I have AR32 and Tango also.

The tango and AR32 will work. It is best done out of circuit.

You can add the key by tango too i think. The eeprom would be 8 legs eeprom not difficult to read .

 

Q: Can you share details with us if you have a good success?

A: I tried to do one with vvdi 2 last year and i could not figure it out. I do us the prog to read and write these.