This step-by-step tutorial explains how to replace a dead or faulty battery in your Xhorse Dolphin II XP-005L key cutting machine. Follow these instructions to safely remove the old battery pack, install the new one, and reassemble the unit.

Tools Required

• Xhorse Dolphin II (XP-005L)key cutting machine
• 5 mm hex Allen key
• Replacement battery pack

Step 1: Remove Both Side Panels

1. Use the 2.5 mm hex key to loosen and remove the screws holding both side covers in place.
2. Take off the side panels and keep the screws together in a safe spot for reassembly.

Step 2: Open the Bottom Cover

1. Carefully turn the machine onto its side.
2. Remove the top rubber foot on the front side, then unbolt the six screws holding the base cover.
3. Lift the base cover off to reveal the inner battery compartment.

Step 3: Remove the Old Battery

1. Remove the four mounting screws holding the battery in place (two located at the top and two at the bottom).
2. Unplug the four electrical connectors behind the battery, then lift the old battery out of the machine.

Step 4: Install the New Battery

1. Plug all four connectors firmly into the replacement battery before placing it inside the housing.
2. Align the battery in its compartment and reinstall the four retaining screws.

• Tip:Start by threading the top screws first to hold the battery steady, then tighten all screws snugly without over-tightening.

Step 5: Reassemble the Machine

1. Reattach the base cover and front foot pad. Fasten the six base screws, starting with the top ones to keep the cover aligned.
2. Reinstall both side panels and secure them with their corresponding screws.

Step 6: Test and Verify

Power on your Dolphin II XP-005L

Confirm that the machine boots up smoothly and that the battery status indicator shows a full or nearly full charge.